![]() ![]() That blurred and faded effect is eye-catching. The characteristic “fade” effect is produced because the lengths blend into each other with no harsh lines. For example, from a zero at the bottom to a #0.5, #1, and then a #2 at the top of the sides. The clipper is then used to gradually increase the length in small increments, going up from the #0 length at the bottom. However, it won’t be as long as it would be if you were to attach a #0.5 guard or #1 guard, for instance. ![]() ![]() Leaving the lever open with no guard attached will allow you to get very slightly longer stubble. The lever of the clipper can be used to adjust the stubble length as well. The stubble length will usually be around 0.5 and 0.8mm when you use the clipper with no guard attached – it really depends on the blade height and the clipper you’re using.Ī standard Wahl blade will usually trim down to 0.8mm, while the #000 blade of an Oster or Andis clipper will trim down to approximately 0.5mm. It doesn’t require shaving – you don’t need a razor to produce it because you aren’t shaving all the way down to the skin.Ī clipper with no guard attached is used to produce the short stubble at the bottom of the sides and back. Notice the slight shadow left behindĮssentially, a zero fade haircut is one step longer than a skin fade. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |